How exactly do you install Pergamon Museum? Is it only for multiplayer or single? Thanks!

put the pk3 in your call of duty/main directory

also read the readme on how to increase your used ram to properly run the map - because it chews alot of ram and can cause your comp to crash or give this error:

CLParse_gamestate: bad command byte

and btw it IS a multiplayer map

Ok, I opened the program folder, found call of duty, and unzipped the entire folder into the main folder. I still don't see the game in the multiplayer mode. What gives?

ok - WHAT exactly have you downloaded?

if you have a .pk3 file you need to do nothing more than put it in your main directory

ensure that the pergamonmuseum.pk3 is IN your MAIN directory

then open call of duty multiplayer
press the tilade key "~" and type

map pergamonmuseum

thismight not be the correct map name as it depends on what version you have

ALSO NOTE:

the most current version of the map has a VERY IMPORTANT CHANGE TO THE README

ensure that you read it and do the recommended change or your game will constantly crash

The file I downloaded which appears to have the new map in it is zipped. When I unzip it, I then try and place it in the main folder. Thanks.

ok - make sure that after you unzip it it is where it needs to be (CoD/main/map.pk3)

sometimes due to the way they get packed - a map will unzip into a folder within the main (i.e. CoD/main/folder/map.pk3)

if that happens - cut the pk3 from the folder and paste it directly into your main

then OPEN the pk3 with winrar or winzip and READ the readme

then (after doing what it says) open call of duty mp and you can start a new server with the pergamon map and test it or play it that way

check your pm's

Thanks for all the assistance!

hee dude how do i increase used ram

bring down the console and type

seta com_hunkmegs "256"

then press enter and try the map...you should only need to do this once and it will be written into your cfg