Hello, i have make a doorway and he works but i saw the tut. about make holes for windows but it doesn't work by me when i press x and try click on the point where i want the window disapears the whole wall till the point where i clicked can someone help me?



Greats Dutchman,!

then press shift and enter, you will have two parts of the wall, like a saw went thru it.

ok, i did but how do you delete that little part? cause i have everywhere lines now, :D

Thanks for helping i got it!

Thank you!

select your section of wall, press x (I think you know this part) select a position at the top or bottom for the first side of your window, select the corresponding point at the other side, You may now see a part of the wall disappear (dont worry) press shift and enter. You have now got two parts, go further along your wall (for the width of your window) and repeat the process. Now select the piece of wall where the window is going to be, press x again and select the two points accross where you want the top of the window. Once again you may see a part disappear once again hold down shift and press enter. Do the same for the bottom edge of the window.

Now select only the section that is to be the window opening and hit backspace to delete it...... done you should now have a window hole in your wall.

Greets dadofazz

And I see I'm too late lol

edited on Jun. 1, 2006 09:12 am by DadofAzz